About the Network Jack
5
1 Ethernet uplink
port
Connects the Network Jack to the network.
Make sure the port on the network switch
to which the Network Jack is connected is
configured as a standard MDI-X port.
2 Slot for adapter
plate
Can be fitted with an adapter plate, which can
be installed with up to two pass-through ports.
3 Adapter plate
with installed
pass-through
port connector
Connects the installed pass-through port to
the network.
4 Dip switches Determine the type of Power Over Ethernet
(Capacitive Power Discovery Process 24V or
48V or IEEE 802.3af) the Network Jack uses.
Setting the dip switches is required only if your
network supports Power Over Ethernet, or if
you are using a multi-port Ethernet power
supply. See “Setting the Power Over Ethernet
Dip Switches” on page 13 for instructions.
