FUNDAMENTAL SAFETY INSTRUCTIONS
1. Basic operation and designated use of the machine.
1.1 The machine has been built in accordance with state of the art standards and recognized safety
rules. Nevertheless, its use may constitute a risk to life and limb of the user and of the third
parties, or cause damage to the machine and to other material property.
1.2 The machine must only be used in technically perfect conditions in accordance with its designated
use and the instructions set out in the operation manual. Only safety-conscious persons who are
fully aware of the risks involved in operation the machine should operate it. Any functional
disorders, especially those affecting the safety the safety of the machine, should therefore be
rectified immediately.
1.3 The machine is designed exclusively for drilling, grinding and milling operations. Using the
machine for purposes other than those mentioned above is considered contrary to its designated
use. The manufacturer cannot be held liable for any damage resulting from such use. The risk of
such misuse lies entirely with the user. Operating the machine within the limits of its designated
use also involves observing the instructors set out in the operation manual and complying with the
inspection and maintenance directives.
2
. Organizational measures.
2.1 The operating instructions must always be at hand at the place of use of the machine.
2.2 In addition to the operating instructors, observe and instruct the user in all other generally
applicable legal and other mandatory regulations relevant to accident prevention and
environmental protection. Those compulsory regulations may also deal with the handling of
hazardous substances, issuing and/of wearing personal protective equipment.
2.3 The operations instructions must be supplemented by instructions covering the duties involved in
supervising and notifying special organizations, working sequences or the personal entrust with
the work.
2.4 Personal entrust with the work on the machine must have read the operating instructions and in
particular the chapter on safety before beginning work. Reading the instructions after work is too
late. This applies especially to persons working only occasionally on the machine e.g. during
setting up or maintenance.
2.5 Check whether personal is carrying out the work in compliance with the operation instructions and
paying attention to risks and safety factors.
2.6 For reasons of security, long hair must be tied back or otherwise secured, garment must be close
fitting and no jewelry, such as ring, may be worn. Injury must result from being caught up in the
machinery or from rings catching on moving parts.
2.7 Use protective equipment whenever required by the circumstances or by law.
2.8 Observe all safety instructions and wearing attached to the machine.
2.9 See to it that safety instructions and wearing attached to the machine are always complete and
perfectly legible.
2.10 In the event of safety-relevant modifications or changes in the behavior of the machine during
operation, stop the machine immediately and report the malfunction to the competent person.
2.11 Never make any modifications, additions or conversions, which might affect safety without the
suppliers’ approval. This also applies to the installation and adjustments of safety devices and
valves.
2.12 Spare parts may comply with the technical requirements specified by the manufacturer. Spare
parts from original equipment manufacturers can be rely to do so.
2.13 Never modify the software of programmable control systems.
2.14 Adhere to prescribe intervals or those specified in the operating instructions for routine checks and
inspections.
2.15 For the execution of maintenance work, tools and workshop equipment adapted to the task on
hand are absolutely indispensable.
2.16 A portable fire extinguisher must be placed within immediate reach.
2.17 Observe all fire warning and fire-fighting.
3
. Selection and qualification of personal-basic responsibilities
3.1 Any work or and with the machine be executed by reliable personnel only. Statutory minimum age
limits must be observed.
3.2 Employ only trained or instructed stuff and set out clearly the individual responsibility of the
personnel of operation, set-up, maintenance and repair.
3.3 Make sure that only authorized personnel work on or with the machine.
3.4 Define the machine operators’ responsibilities – giving the operator the authority to refuse
instructions by third parties that are contrary to safety.
3
