6.2 Work on the electrical system or equipment may only be carried out by a skilled electrician himself
or by specially instructed personnel under the control and supervision of such electrician and in
accordance with the applicable electrical engineering rules.
6.3 If provided for in the regulations, the power supply to parts of machine, on which inspection,
maintenance and repair work has to be carried out, must be cut off. Before starting any work,
check the de-energized parts for the presents of power and ground or short-circuit in addition to
insulating adjacent live parts and elements.
6.4 The electrical equipment of machine is to be inspected and checked at regular intervals. Defects
such as loose connectors or scorched cable must be rectified immediately.
6.5 Necessary work on live parts and elements must be carried out only in the presence of a second
whom can cut off the power supply in case of danger by actuating the emergency shut-off or main
power switch. Secure the working area with a red-and-white safety tape and a warning sign. Use
insulated tools only.
6.6 Check all lines, hose and screwed connections regularly for leaks and obvious damage. Repair
damage immediately.
6.7 Depress all system sections and pressure pipes to be removed in accordance with the specific
instructions for the unit concerned before carrying out any repair work.
6.8 Compressed air lines must be laid and fitted promptly. Ensure the no connections are
interchanged. The fittings, length and quality of the hoses must comply with the technical
requirements.
7.
Mobile machinery and equipment
7.1 Cut off the external power supply of the machine even if only minor changes of place are envisage.
Properly reconnect the machine to the supply mains before restarting.
7.2 For restarting process only in accordance with the operating instructions.
WARRANTY NOTICE
We warrantee this spindle to be free of material and workshop defects. This warrantee is
conditional upon proper use in the applications of which this spindle is designed to. Warrantee is void if
damaged caused due to improper use, installation, negligence, accident, inadequate maintenance to the
spindle or the machine in which it is installed. This warrant is also void if customer did not follow the
complete manual and caused damage.
In any case of damage, failure analysis will be perform by Plasel to determine the cause of the
failure. Warrant is void if damaged caused by inadequate machine maintenance or improper use ex. Leaky
valves, Z-axis leakage wear, contained air supply, lower/higher air presser, inadequate vacuum, using the
spindle to work on material that is too hard, drilling into anything other then the right material.
5
