A SERVICE OF

logo

xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
368
disable qinq
Purpose Used to disable the Q-in-Q mode.
Syntax
disable qinq
Description This command is used to disable the Q-in-Q mode.
All dynamically learned L2 address will be cleared. All dynamically registered VLAN
entries will be cleared. GVRP will disable. If you need to run GVRP on the switch, you
shall enable GVRP manually.
All existed SP-VLAN will run as static 1Q VLAN.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To disable Q-in-Q:
DGS–3426:5#disable qinq
Command: disable qinq
Success.
DGS–3426:5#
show qinq
Purpose Used to display global Q-in-Q
Syntax
show qinq
Description The command is used to display the global Q-in-Q status
Parameters None
Restrictions None.
Example usage:
To display global Q-in-Q status:
DGS–3426:5#show qinq
Commands: show qinq
QinQ Status: Enabled
DGS–3426:5#