Selecting the Module
Before you can program the logic analyzer, you must first "select" it. This
directs your commands to the logic analyzer.
To select the module, use the system command :SELect followed by the
numeric reference for the slot location of the logic analyzer (1 through 10
refering to slots A through J respectively). For example, if the logic analyzer
is in slot E, then the command:
:SELect 5
would select this module. For more information on the select command,
refer to the HP 16500/16501A Programmer’s Guide. It is available through
your HP Sales Office.
Programming the Logic Analyzer
A typical logic analyzer program will do the following:
•
select the appropriate module
•
name a specified analyzer
•
specify the analyzer type
•
assign pods
•
assign labels
•
sets pod thresholds
•
specify a trigger condition
•
set up the display
•
specify acquisition type
•
start acquiring data
Programming the HP 16554A/ HP 16555A/HP 16555D
Selecting the Module
1–3
