Filter
Top Products
The M3000SiDAA interpolator module can be configured quickly and easily using the SmartPrecision Software. The M3000SiDAA inter-
polator will accept input from two separate encoders. The M3000SiDAA has three output channels. These can be configured to output
the following: Channel 1, Channel 2, Average ((Ch1+Ch2)/2), and/or Difference (Ch1-Ch2). The main screen shows Encoder Position,
Signal Level, Alarm Status, Data Plots, and Setup.
Encoder Position:
The Encoder Position box displays the current position data for each of the three output channels.
Each output can be reset or zeroed independently. The units can be changed from encoder counts, to any number of linear or rotary units.
SSeettuupp
Calibrate: Starts the calibration routine for the selected channel.
Configure: Allows user to configure the Input and Output Channel settings,
Calibration settings, SPI settings, and Hardware/Communication
settings
Display Settings: Configures the SmartPrecision Software Display
DDaattaa PPlloottss
Encoder Signal: Displays the encoder signal plot for each input channel
Signal Strength: Displays the encoder signal strength for each in out channel.
Encoder Position: Displays the encoder position for each in out channel.
Configuration and Setup - SmartPrecision Software
Main Screen
Page 14