Filter
Top Products
52 DMM 12BC
Operation
Audio level display / VU function:
NOTE
If the LEVEL function is selected, the set level is displayed on the LED rings of the inputs and
outputs.
Briefly pressing the "SYSTEM CONTROL" rotary control switches the display on the LED rings
to VU meter, the display of the actual audio level present. As long as the VU meter mode is
activated, the LEVEL LED flashes on the "SYSTEM CONTROL" rotary control. Pressing the
"SYSTEM CONTROL" rotary control again deactivates the VU meter mode.
System control
Figure 16: SYSTEM CONTROL rotary knob
To adjust the unit parameters, select the desired mode on the "SYSTEM CONTROL" rotary
knob.
1) Select the function you require using the "SYSTEM CONTROL" rotary knob. Turn the
rotary knob until the LED for the required function lights up.
2) Control the input channels by using the function selected with the rotary knobs "IN 1" to
"IN 12".
3) Control the output channels by using the function selected with the rotary knobs "OUT 1"
to "OUT 2".
4) Control the headphone stereo output channel using the "HEADPHONE" rotary knob.
The stereo recording output and the digital output have no setting options.
NOTE
The "SYSTEM CONTROL" rotary knob returns to the "LEVEL" function five minutes after the last
change. The set value is automatically stored one minute after the last change.
The following functions can be selected:
x Level
x Treble
x Bass
x Low Cut
x Limiter
x Compressor
x Automixing
x Priority
x Pan / Balance
x Delay
x Routing to OUT 1
x Routing to OUT 2
x Routing to REC
x Routing to DIGOUT
x Equalizer