Filter
Top Products
14 EUROPOWER PMP1000/PMP4000/PMP6000 User Manual
Installation4.
Mains connection4.1
The mains connection is made using the enclosed power cord and a standard IEC
receptacle. It meets all of the international safety certification requirements.
Blown fuses must be replaced by fuses of the same type and rating.
Please make sure that all units have a proper ground connection. ◊
For your own safety, never remove or disable the ground conductor
from the unit or of the AC power cord.
Audio connections4.2
The inputs and outputs of your BEHRINGER EUROPOWER are unbalanced ¼" mono
jacks—except for the mono channel line inputs, which are balanced ¼" stereo
jacks. Of course, all inputs and outputs work with both balanced and unbalanced
connectors. The tape in and outputs are on RCA connectors.
Please ensure that only qualified personnel install and operate the ◊
PMP. During installation and operation, the user must have sufficient
electrical contact to earth. Electrostatic charges might affect the
operation of the unit.
Strain relief clamp
Sleeve
Tip
Sleeve
(ground/shield)
Unbalanced ¼" TS connector
Tip
(signal)
Fig. 4.1: ¼" TS connector
strain relief clamp
sleeve
ring
tip
sleeve
ground/shield
For connection of balanced and unbalanced plugs,
ring and sleeve have to be bridged at the stereo plug.
Balanced ¼" TRS connector
ring
cold (-ve)
tip
hot (+ve)
Fig. 4.2: ¼" TRS connector
output
For unbalanced use, pin 1 and pin 3 have to be bridged
1 = ground/shield
2 = hot (+ve)
3 = cold (-ve)
input
12
3
1
2
3
Balanced use with XLR connectors
Fig. 4.3: XLR connectors