Filter
Top Products
E-24
703A-E-026A
Changing the Settings of REVERB and
CHORUS Parameters
You can control the relative strength of an effect and how it is
applied. The parameters you can control depend on the ef-
fect. See the following section titled “REVERB and CHORUS
Parameters” for more information.
1. After selecting the effect you want, press the [̄]
(ENTER) button.
• This displays the parameter setting screen.
2. Use the [̇] and [̈] (CURSOR) buttons to dis-
play the parameter whose setting you want to
change.
Example: To set the Reverb Time parameter
3. Use the [+] and [–] buttons or the number but-
tons to input the parameter setting you want.
4. Press the [̆] (EXIT) button.
• This returns to the effect selection screen.
REVERB and CHORUS Parameters
The following describes the parameters for each effect.
REVERB
Reverb effects are associated with either a reverb type or de-
lay type. Parameter settings depend upon the associated type.
● Reverb Type (No. 0 to 5, 8 to 13)
■
Reverb Level (Range: 000 to 127)
Controls the reverb size. A larger number produces larg-
er reverb.
■
Reverb Time (Range: 000 to 127)
Controls how long reverb continues. A larger number
produces longer reverb.
■
ER Level (Initial Echo Sound) (Range: 000 to 127)
This parameter controls the initial reverb volume. The
initial echo sound is the first sound reflected from the
walls and ceiling when a sound is output by this key-
board. A larger value specifies a larger echo sound.
■
High Damp (Range: 000 to 127)
Adjusts the damping of high frequency reverberation
(high sound). A smaller value damps high sounds, creat-
ing a dark reverb. A larger value does not damp high
sounds, for a brighter reverb.
● Delay Type (No. 6, 7, 14, 15)
■
Delay Level (Range: 000 to 127)
Specifies the size of the delay sound. A higher value produc-
es a larger delay sound.
■
Delay Feedback (Range: 000 to 127)
Adjusts delay repeat. A higher value produces a greater num-
ber of repeats.
■
ER Level
Same as Reverb Type
■
High Damp
Same as Reverb Type
CHORUS
■
Chorus Level (Range: 000 to 127)
Specifies the size of the chorus sound.
■
Chorus Rate (Range: 000 to 127)
Specifies the undulation speed of the chorus sound. A
higher value produces faster undulation.
■
Chorus Depth (Range: 000 to 127)
Specifies the undulation depth of the chorus sound. A
higher value produces deeper undulation.
❚
NOTE
• Whether or not an effect is applied to the parts that are sound-
ing also depends on Mixer Mode Reverb Send, Chorus Send,
and DSP on/off settings. See “Mixer Function” on page E-35
for more information.
REVERB
CHORUS
DSP [̄] ENTER
[+]/[–]
[̇] / [̈] CURSOR
[̆] EXIT
Number buttons
R v b T i m e