Filter
Top Products
E-26
❚
NOTE
• Whether or not an effect is applied to the parts that are sound-
ing also depends on Mixer Mode Reverb Send, Chorus Send,
and DSP on/off settings. See “Mixer Function” on page E-35
for more information.
• Playing a demo tune (page E-15) automatically changes the
effect to the one that is assigned to the tune. You cannot change
or cancel a demo tune effect.
• Changing the effect setting while sound is being output by the
keyboard causes a slight break in the sound when the effect
changes.
• A number of tones, called “Advanced tones,” automatically turn
on the DSP line for more effective tones. If you assign an Ad-
vanced tone to a keyboard part (Channels 1 through 4), the
DSP line turns on automatically and the DSP selection chang-
es in accordance with the settings of the Advanced tone. Also,
the Mixer Mode DSP line on/off setting for the keyboard part to
which the Advanced tone is assigned is turned on.*
* The Mixer DSP line setting is automatically turned off for each
part that does not have an Advanced Tone assigned.
Because of this, DSP effects previously applied to these parts
are cancelled, which can make their tone sound different. In
this case, display the Mixer screen and turn DSP back on.
703A-E-028A
[̄] ENTER
[+]/[–]
Saving the Settings of DSP Parameters
You can save up to 10 modified DSPs in the user area for
later recall when you need them.
1. After making the DSP parameter settings you
want, press the [̄] (ENTER) button.
• This causes the DSP number of the user area where
the DSP will be saved to flash on the display.
2. Use the [+] and [–] buttons to select the user
area DSP number where you want to save the
new DSP.
• You can select a user area DSP number in the range of
100 to 109 only.
3. After everything is the way you want, press the
[̄] (ENTER) button to store the effect.
• The message “Save OK” appears momentarily on the
display, followed by the tone or rhythm selection
screen.