Filter
Top Products
E-25
703A-E-027A
Selecting a DSP Type
1. Press the DSP button so the indicator appears
next to DSP on the display.
2. Use the [+] and [–] buttons or number buttons
to select the type of DSP you want.
• See the “Effect List” on page A-10 for information
about the DSP types that can be selected.
• Here you could also change the parameters of the ef-
fect you selected, if you want. See “Changing the Set-
tings of DSP Parameters” for more information.
❚
NOTE
• When using a DSP effect, you should use the Mixer to confirm
that the DSP lines of the required parts are turned on. See
“Mixer Function” on page E-35 for more information.
• The DSP type display area shows the DSP number (000 to
109), Ad (Advance tone), or USr (user tone created using DSP).
Setting Basic DSP Parameters
The following are the basic DSP parameters whose settings
you can change.
■
DSP Volume (Range: 000 to 127)
Sets the post-DSP volume.
■
DSP Pan (Range: -64 to 00 to +63)
Sets the post-DSP stereo pan.
■
DSP Hold (Settings: on, oFF)
on: Current DSP line setting is maintained, even when
the tone is changed.
• In the case of an Advance tone, however, changing the
tone causes all DSP line settings except for those of the
selected channel to turn off. See the note on page E-26
for more information.
oFF: Changing the tone switches to the DSP line setting
of the new tone.
1. Press the DSP button so the on-screen DSP indi-
cator appears.
2. Use the [̇] and [̈] (CURSOR) buttons to dis-
play the parameter whose setting you want to
change.
3. Use the [+] and [–] buttons or the number but-
tons to make the parameter setting you want.
4. Press the [̆] (EXIT) button.
• This exits the tone or rhythm setting screen.
Changing the Settings of DSP Parameters
You can control the relative strength of a DSP and how it is
applied. See the following section titled “DSP Parameters”
for more information.
1. After selecting the DSP type you want, press the
[̄] (ENTER) button.
• This displays the parameter setting screen.
2. Use the [̇] and [̈] (CURSOR) buttons to dis-
play the parameter whose setting you want to
change.
3. Use the [+] and [–] buttons or the number but-
tons to make the parameter setting you want.
4. Press the [̆] (EXIT) button.
• This exits the DSP type setting screen.
DSP Parameters
The following describes the parameters for each DSP.
DSP
■
Parameter 0 to 7
This parameter differs in accordance with the algorithm*
of the selected DSP type. See the “Effect List” on page A-
10 and the “DSP Algorithm List” on page A-12 for more
information.
* Effector structure and operation type
■
DSP Reverb Send (Range: 000 to 127)
Specifies how much of the post-DSP sound should be sent
to reverb.
■
DSP Chorus Send (Range: 000 to 127)
Specifies how much of the post-DSP sound should be sent
to chorus.