Filter
Top Products
44
CONTROL SWITCH SETTINGS
You can make the following control switch settings independently for each program.
Press the EXP/CTL button and use value knob 5 to select the effect you want to
control.
SWITCHING EACH EFFECT ON/OFF
NOTE: The CONTROL switch LEDs indicate the on/off status.
USING TAP TEMPO TO SET A PARAMETER
NOTE: The CONTROL switch LED will blink at the tempo you specify.
NOTE: The maximum tap interval is 10 seconds.
EFFECT CONTROL
NOTE: If you haven’t selected an applicable effect, nothing will be controlled.
HINT: When you set the delay effect type to “HOLD DELAY” or “FREEZ,” the con-
trol switch will automatically be assigned to “HOLD DLY” or “FREEZ.” In this case,
the target will automatically return to its original setting if you change the delay
effect to another type without performing any other operation.
•“I/ON OFF” External effect insertion on/off
•“P/ON OFF” Pre-effect on/off
•“A/ON OFF” Drive/Amp model on/off
•“M/ON OFF” Modulation effect on/off
•“D/ON OFF” Delay effect on/off
•“R/ON OFF” Reverb effect on/off
•“MOD TAP” Use TAP TEMPO to set the SPEED parameter of the
modulation effect
•“DLY TAP” Use TAP TEMPO to set the TIME parameter of the delay
effect
•“FLN TRIG” LFO START TRIGGER of the CLASSIC FLANGER effect
•“ROT SPD” SPEED SW of the ROTARY effect
•“HOLD DLY” HOLD of the HOLD DELAY effect
•“FREEZ” ON of the FREEZ effect