Filter
Top Products
Editing a song > Setting Cycle Play
34
Editing a song
After having been recorded, a user-created song can be edited, and then saved again in the User Song album. Please note that songs con-
tained in albums other than UserSong cannot be edited. The only Edit function that can be accessed with these songs is the Cycle Play.
Setting Cycle Play
Cycle Play allows you to repeat a passage during play, to prac-
tice with it over and over.
Note: If you enter editing later, you might see a different edit
page instead of the first one. Use the SCROLL
button to
reach it.
1. While in Song Play mode, press the EDIT button. The first
page of the Song Edit mode will appear. This is the Cycle
Play mode, whose use has been seen above (see “Cycle
Play” on page 26):
2. Press the EXIT button to return to the Main page and start
practicing.
Erasing a track
You can erase a single or all song tracks, to start recording
them again, or just remove them from the song (for example,
the voice track you want to sing live).
1. After having pressed the EDIT button, use the SCROLL
button to go to the Erase Track edit page:
2. Use the +/YES and -/NO buttons to select one of the fol-
lowing tracks:
3. Press the SCROLL
button to move the cursor to the
Exec command.
4. Press +/YES to start erasing. The “Are you sure?” message
appears. Press +/YES to confirm, -/NO to cancel and keep
the track.
5. Press the EXIT button to return to the Main page and save
the changes (see “Saving the song after editing” on page 36),
or the SCROLL
button to go to the next edit page (see be-
low).
Cycle Play 1
On S:001 E:001
End Measure
Start Measure
Option Meaning
All All tracks – this results in an empty song
Tr01 (P2), Tr02 (P1) Respectively, Recorder Parts 2 (Track 1)
and 1 (Track 2)
Tr 10 (Dr) Drum part (Track 10)
Tr03 ~ 09, 11 ~ 16 Tracks 3 ~ 9, 11 ~ 16 (Extra tracks)
Erase Track 2
All Exec?
C720_English.fm Page 34 Tuesday, October 10, 2006 4:14 PM