Filter
Top Products
Parameters
17
Parameters
1. Normal Edit mode /
EX Edit mode
When you press a PROGRAM [1]–[8] key in Normal
Edit mode or EX Edit mode, the first parameter in
the Group 1–Group 8 listed below will be selected
directly.
Group 1
Set the output level, tone wheel, and click level.
Group 2
Set the drawbar levels for the Upper tone generator
and the Lower tone generator.
The displayed parameters will differ between Normal
Edit mode and EX Edit mode.
Group 3
Specify how the keys of the PERCUSSION section will
function.
Group 4
Adjust the amp settings.
Group 5
Adjust the reverb settings.
Group 6
Adjust the rotary speaker settings.
Group 7
Set the split point, and specify the function of the
pedal connected to the ASSIGNABLE PEDAL/SW
jack.
The displayed parameters will differ between Normal
Edit mode and EX Edit mode.
Group 8
Change the program name.
Group 1
Output Level [0...127]
Specify the output level of the program.
Wheel Type [Vintage, Clean]
Select the type of tone wheel.
Vintage: A tone wheel with leakage noise.
Clean: A tone wheel without leakage noise.
Over Tone Level [0...99]
Specify the overtone level of the tone wheel.
Leakage Level [0...99]
Specify the level of the leakage noise.
On Click Level [0...99]
Specify the level of the click noise at key-on.
Off Click Level [0...99]
Specify the level of the click noise at key-off.
Group 2
UPPER (Upper Drawbar Level) [0...8]
This parameter is displayed in Normal Edit mode.
Specify the level for each drawbar used by the Upper
tone generator. From the left, the display corresponds
to the 16', 5-1/3', 8', 4', 2-2/3', 2', 1-3/5', 1-1/3', and 1'
bars.
When a bar is pulled out all the way, its level will be 8.
In Normal mode, pressing the [DISPLAY] key once
when the program name is displayed will show the
levels that you specified here.
The front panel Drawbar 1 or Drawbar 2 settings can
be copied instantly to the parameters of a program.
For details refer to “Copying drawbar parameters”
(p.14).
LOWER (Lower Drawbar Level) [0...8]
This parameter is displayed in Normal Edit mode.
Specify the level for each drawbar used by the Lower
tone generator. From the left, the display corresponds
to the 16', 5-1/3', 8', 4', 2-2/3', 2', 1-3/5', 1-1/3', and 1'
bars.
When a bar is pulled out all the way, its level will be 8.
In Normal mode, pressing the [DISPLAY] key twice
when the program name is displayed will show the
levels that you specified here.
The front panel Drawbar 1 or Drawbar 2 settings can
be copied instantly to the parameters of a program.
For details refer to “Copying drawbar parameters”
(p.14).