Filter
Top Products
14
Using the music stand
To use the music stand, insert it into the two holes located on the rear panel.
Turning the power on
1
Connect the AC/AC power supply
Insert the round connector of the AC/AC power adaptor into the AC9V jack located on
the rear of the SP-500.
Connect the plug of the AC/AC power supply to an electrical outlet.
The [POWER] switch of the SP-500 must be off when you connect the AC/AC power
supply. Also, you must connect the power supply to the rear panel AC9V jack before
you connect it to the electrical outlet.
You must use only the included AC/AC power supply. Make sure that your electrical
outlet is supplying the correct voltage for your SP-500.
2
Turn on the power
Press the [POWER] switch located on the rear panel. When you turn on the power, the
panel indicators will light, and the startup screen will appear.
Turning the power off
Press the [POWER] switch once again. When the power is turned off, the panel indica-
tors will all go dark.
If you turn off the power while data is being written, the memory contents may be
damaged. If the memory contents are damaged, the user rhythm styles, user programs,
and All Setup data will automatically return to their factory-set condition the next time
the power is turned on. If part of the recorded data has also been damaged, all of the
recorded data will return to the factory-set condition.
Adjusting the volume
Use the [MASTER VOLUME] slider to adjust the volume of the head-
phone jacks and rear panel [OUTPUT] jacks.
Raise the [MASTER VOLUME] slider to the middle position. Moving the
slider toward the right will increase the volume, and moving it toward
the left will decrease the volume. At a position of “0” there will be no sound.
While actually playing the instrument, adjust the volume to an appropriate level.
~AC9V
Softer Louder