Filter
Top Products
25
Bank Dump
Lets you copy an entire bank of presets from the PCM96 to another
device via MIDI. (For a map of banks and presets, see page 29; to see
the current preset’s bank number, press Knob C while viewing the Preset
screen.) When Bank Dump is highlighted, turn the corresponding B or C
Knob to select a bank. Press the corresponding B or C Knob to send the
bank to the connected device.
teMPo coNtRoL
The Tempo Control sub-menu contains the following options:
Tempo Value
Set the current preset’s tempo here by turning Knob A, or by pressing the
Tap Tempo button at least two times.
Tempo Beat
Tempo is expressed in BPM. This control allows you to specify the value
of the beat. Eighth, quarter, and half note values are available. If, for exam-
ple, the rate is 120 BPM, and you select eighth-note here, the tempo will
be 120 eighth-notes per minute. If you select quarter-note here, the tempo
will be 120 quarter-notes per minute. (The factory default is quarter-note.)
Tempo Source
Select INTERNAL to determine the tempo using parameters within the
PCM96, or MIDI to set the tempo using MIDI beat clock. Refer to your
DAW’s manual to learn how to transmit this value.
cARd coNFIG
The Compact Flash Setup sub-menu indicates whether a Compact Flash card
is INSERTED or NOT INSERTED, and gives you the options to Format
(erase) the inserted card by pressing Knob B, or initializing the inserted card
by pressing Knob C.
NetWoRK coNFIG
Here you can set the PCM96 Subnet Mask, IP Address, Gateway, and
DHCP information. Turn the Select knob to select a three-digit number (of
the DHCP value) and turn Knob A to change the number (or the DHCP
value). See the Networking section on page 19 for more details.
hIQNet coNFIG
Set the HiQnet Negotiation Mode (Static, Random, or Sequential) and
Node Address here. Turn the Select knob to underscore a value and turn
Knob A to change the value.
ReStoRe FActoRy deFAULtS
Returns the PCM96 to its original state as shipped from the factory.