Filter
Top Products
68 Chapter 7: Output Section
VeniceU
Operator Manual
Auxes
There are four independent aux outputs on the rear panel.
Four aux XLR outputs on the rear panel
Each aux output is controlled by a discrete section on the control surface.
Auxes on the control surface
Pre-fade aux 1-4 sends are sourced after the channel insert, mute and EQ, but before
the channel fader. As a result, the actual level sent to the aux bus is proportional to the
aux send control only.
Post-fade aux sends are sourced after the channel insert, mute, EQ and fader. As a
result, the actual level sent to the aux bus is proportional to the aux send control and
the channel fader.
Item Description
1 Control knob Adjusts the aux master level. The output level of the aux is
continuously variable from
4 (infinity/off) to +10dB.
2 MUTE switch and red LED The MUTE switch mutes the aux send signal
at every point after the master send level. The LED illuminates to show
when the mute is on.
3 SOLO switch and yellow LED The SOLO switch routes the aux send
signal to the mono PFL bus and stereo AFL buses. The solo LED illuminates
to show when solo is on.
4 pre switch This is the aux global control bus master pre-fader switch,
which determines whether the aux contribution from the input channel is
pre-fader or post-fader.
5 aux c/o switch See “Group-aux changeover” on page 60
1
2
3
4
5