Filter
Top Products
Master outputs (mono and stereo) 69
VeniceU
Operator Manual
Table 2: Typical uses of auxiliaries
Master outputs (mono and stereo)
There is an output connector and insert connector on the rear panel for each of the
mono, left and right master channels.
Master outputs on the rear panel
USB output is available for the left and right master channels by the overriding the
relevant multifunction input channel. There is no USB output for the mono channel.
For more information, see “USB” on page 62.
The controls shown in this section are directly responsible for the main outputs from the
console.
Application Pre-/Post-fade Reason
Stage monitors Pre-fade (post-EQ) The level in the monitor stays
constant, so that the engineer can
change the FOH level without
affecting the performer.
Effects sends Post-fade The level sent to the effects is
proportional to the fader level, so
the balance between wet
(processed) and dry (unprocessed)
sound stays the same, even when
the channel level is changed.
Mixed recording (for
the artist)
Post-fade (post-EQ) If the aux is set to unity, the FOH
mix is replicated on the aux
output. This includes EQ, but
excludes pan.