Filter
Top Products
INs AND OUTs
23. Mic Input
XLR balanced low impedance input. Pin 2 is the positive input.
24. Hi Z Mic Input
1/4"(TRS) high impedance mic input. This jack is wired in parallel with the Mic Input which is switched out of
circuit when the Hi Z Input is used. The tip is positive input.
25. Dry Output
1/4" (TS) mono output of the preprocessed signal. This is the signal from the preamp before it enters the
compressor or processor circuitry. It will not contain the effects from the processor such as reverb or delay
nor will it be controlled by the level function of the processor or the output level knob.
26. Line Outputs
Two 1/4" (TRS) differential. The signals present at both the Left and Right outputs are the stereo outputs of
the processor. The signal content is determined by the user or factory preset effects parameters. Use these
outputs when your mixer does not have available XLR mic inputs.
27. Mic Outputs
Two (Left and Right) XLR balanced outputs. The signals present at both the Left and Right Mic Outputs are
the stereo outputs of the processor. The signal content is determined by the user or factory preset effects
parameters. The Mic Outputs are the recommended outputs. Always use high quality, shielded mic cables.
28. Auxiliary Input
Stereo 1/4" (TRS) input for use with an external signal source such as tape or CD. (Tip = Left)
29. Headphone Output
Provided for use with any stereo headset. This provides the same outputs as the Left and Right Outputs.
30. AC Power Input
16.5 VAC, 1100 mA external power supply input. Use only the external wall-mount supply provided
(Peavey part #70900660).
8
30 29 28 27 26 25 24 23