Filter
Top Products
23
En
English
Setting the master for synchronization
Click [ ].
The master for synchronization can be selected from one of the two
types below.
— [MASTER]: The BPM value input by the user or the BPM value set
by tapping is set as the master.
— [AUTO]: The master is set automatically. When two decks are
playing and the deck set as the master is paused, the other deck
is automatically set as the master.
Inputting the sound of an external
device or microphone
The sound of the external device connected to the [AUX IN] terminals
or the sound of the microphone connected to the [MIC] terminal can be
mixed.
! When operating on USB bus power, the [AUX IN] and [MIC] termi-
nals cannot be used.
To use without limitations, connect to a power outlet using the
included AC adapter.
1 Connect the external device to the [AUX IN] or [MIC]
terminal.
2 Switch the [AUX, MIC] selector switch.
— [AUX]: Selects the external device connected to the [AUX IN]
terminals.
— [MIC]: Selects the microphone connected to the [MIC] terminal.
3 Make the TRAKTOR 2 software’s
[Preferences]>[Input Routing] setting.
Set [Input Aux] as shown below.
— [L(Mono)]:1:DDJ-T1 AUX/MIC L
— [R]:2:DDJ-T1 AUX/MIC R
! With TRAKTOR Pioneer DDJ-T1 EDITION 2, the above settings are
preset.
4 Adjust the audio level input to the [AUX IN] or [MIC]
terminals.
— Turn the [VOL] control on the main unit’s front panel: The [MIC]
terminal’s input audio level is adjusted.
— Turn the [VOL] control on the main unit’s rear panel: The [AUX
IN] terminals’ input audio level is adjusted.
Pioneer DJ player: Set near the center position.
Portable audio player or other device with low volume: Set clock-
wise of the center position.
5 Turn the TRAKTOR 2 software’s [AUX] knob.
Turn the [AUX] knob at the right of the crossfader and set to a suitable
volume level.
Assigning the sound of an external
device or microphone to a deck
The effect function, filter function and EQ controls can be used when the
sound of the external device or microphone is set to be input to a deck
from [A] – [D].
! The following describes how to assign the sound of an external
device or microphone to deck [D].
1 Click [b] on deck [D].
From the menu, select [Line Input].
2 Make the TRAKTOR 2 software’s
[Preferences]>[Input Routing] setting.
Set [Input Deck D] as shown below.
— [L(Mono)]:1:DDJ-T1 AUX/MIC L
— [R]:2:DDJ-T1 AUX/MIC R
! To set the deck back as it was, click [b] and select [Track Deck].