Filter
Top Products
6
<DRB1314>
1 GND
2 HOT
3 COLD
MIC 2MIC 3CH-4CH - 1
CH-1
CH - 2
CH - 2
CH - 3
CH - 3
CH - 4
CH - 4
CONTROLCONTROLCONTROLCONTROL LINE 1
LINE 1
LINE 3
LINE 3
LINE 5
LINE 5
LINE 7
LINEPHONO
LINEPHONO
LINEPHONO
LEVEL
LEVEL
ATT .
MASTER
TALK OVER
SIGNAL
GND
/ LINE 2/ LINE 4
PHONO 1
/ LINE 2
PHONO 1
PHONO 2
/ LINE 4
PHONO 2
/ LINE 6
PHONO 3
/ LINE 6
PHONO 3
PHONO 4
LINE 7PHONO 4
R
L
R
L
R
L
R
L
R
L
L
L
R
RLR
RL
(MONO)
RL
(MONO)
LR12
BOOTHMASTER
MASTER OUT 2
MASTER OUT 2
DIGITAL OUT
REC OUT
SEND
SEND
RETURN
RETURN
OUT 1 MONITOR
BOOTHMASTER
OUT 1 MONITOR
R L
R L
R L
R L
R L
R L
R L
R L
CMX-3000 / CMX-5000
[A] [B]
CDJ-1000 /
CDJ-100S /
CDJ-700S /
CDJ-500II
[B]
CDJ-1000 /
CDJ-100S /
CDJ-700S /
CDJ-500II
[A]
DJM-3000
Cassette deck, etc.
CONNECTIONS
When connecting or changing the connection of units, make sure to first turn off the power switch and disconnect the power cord
from the outlet.
1. Connection of Input Equipment
Connect to a wall’s
electrical outlet
Player 3 Player 2 Player 1
(PHONO 4 cannot be used
when using MIC 3)
When connecting an analog player to the CH-4 PHONO 4
connectors, first remove the short-circuit pin plugs (2) from
the jacks.
The short-circuit pin plugs are provided to reduce any residual
noise when an analog player is not connected to the PHONO
4 jacks, thus producing the highest possible sound quality.
After removing the pin plugs, store them securely, and
replace them in their original jacks any time an analog player
is not physically connected.
*1 Connect the cord for the analog player’s ground.
This terminal is exclusively for an analog player and is not
a safety earth.
*2 If you are using the unit with the separately sold CMX-
3000, CMX-5000, CDJ-1000, CDJ-100S, CDJ-700S, or
CDJ-500
II connected to the LINE terminals, the fader
start function can be used if the unit and CD player are
connected with a control cord.
*3 Because the unit’s PHONO input terminals are
exclusively for MM, use MM-type cartridges for the
analog player connected.
L
R
White plug
Red plug
*4 When connecting a cassette deck, set the PHONO/LINE
switch to the LINE position.
*5 When connecting an analog record player, set the
PHONO/LINE switch to the PHONO position.
Connecting audio cords
Use the cords with the red and white pin plugs.
Connect the white plug to ”L“ and the red plug to ”R“. Make
sure to insert the plugs completely.