Filter
Top Products
82
To use the Elite Omni-Directional Tabletop Microphone:
1. Remove the microphone from the Charger Base. The microphone will
automatically turn on. Based on settings in the Base DSP, the microphone
will start either un-muted or muted, indicated by green or red blinking
lights, respectively.
2. Omni Tabletop microphones can be centered on the table within 2 to 6 feet
(0.6 to 2m) away from people speaking and do not need to be pointing any
particular direction because they pick up sound from all directions. It is
always better to place a microphone as close to the people speaking as
possible, while avoiding placing the microphone where it might be blocked
by equipment or paperwork. Do not place microphones too close to an
audio or video conference speaker to avoid echoes. Make sure that the
microphone’s rubber feet are sitting atop a flat surface.
3. With the microphone in position on the table, see picture above for an
example, mute or un-mute the microphone by touching any of the four
mute areas (confirm by flashing green or flashing red LEDs, respectively). In
push-to-talk mode, touch a mute area and keep the finger there to unmute
the microphone. Removing the finger from a touch area will mute the
microphone.
4. To turn the microphone off, return it to the Charger Tray or touch and hold
any of the Mute areas for about 10 seconds until the LEDs turn solid red,
then remove the finger from the touch area. The microphone can also be
turned off from the local web UI or the room control interface. In push to
talk mode the microphone cannot be shut down using the mute areas.
If the microphones are placed too far away from the Remote Antenna
(depending on the RF power setting this can be 300 feet, 90 meters, or farther
from the Remote Antenna) the connection will be dropped (LEDs flash red-
yellow-green-yellow) and the microphone will mute. After 15 seconds the
microphone will beep, and will continue beeping every 30 seconds to indicating
that it is out of range.
Move the microphone closer to the Remote Antenna and the connection will
automatically be re-established to its original state, and the beeping will cease.
Otherwise, the microphone will continue beeping until it turns off after about
15 minutes.