Filter
Top Products
136
Chapter 7 Recording/Playing Back What You Play
Re-Recording
If you made a mistake in your performance during recording
etc., you can re-record just a portion of the musical data in
the track.
NOTE
If you wish to re-record with different settings for voices,
tempo, part balance, erase the recorded song (p. 137) and re-
record again. If the Control track still contains data from
before you re-recorded, the volume or sounds may change
during playback.
1. Touch <Rec/Play> on the Main screen.
The Rec/Play screen appears.
fig.07-04_50
2. Touch the <Bwd> and <Fwd> buttons to select
the desired measure (bar) when you start
recording.
If you wish to start recording from the beginning of the
song, touch the <Reset> button.
3. In the Rec/Play screen, touch <Rec> to enter
recording-standby mode.
<Play> and the unrecorded track buttons in the screen
will blink. The button indicators of tracks that are
already recorded will light.
fig.07-15
Also, the panel Composer [Rec] button indicator will
light, and [Play/Stop] button will blink.
You can also enter recording-standby mode by pressing the
Composer [Rec] button.
4. Touch the Track button which you wish to re-
recording (button flashes).
The song data of the specified Track (with the exception
of the Control Track) will be erased as new song data is
recorded.
When the Track button is lit constantly, no song data has
been recorded on that Track.
5. In the Rec/Play screen, touch <Play> to begin
recording.
The metronome will sound a two-measure count, and
then recording will begin.
You can also start recording by pressing the Composer
[Play/Stop] button.
6. In the Rec/Play screen, touch <Stop> to stop
recording.
The buttons of tracks which were re-recorded will
change from flashing to being constantly lit.
You can also stop playback by pressing the Composer [Play/
Stop] button.
NOTE
If you wish to keep the existing Expression Pedal data, and
record only the panel operations, you can make settings to
prevent the operation of the Expression Pedal from being
recorded (p. 162).
You can use punch-in recording (p. 144) to re-record only the
area that you specify.
blinklit
Min
Max
Min
Max
Min
Max
Min
Max