Filter
Top Products
82
Chapter 3 Using the Registration Buttons
Formatting Disks
Before any floppy disk (new or used) can be used with the AT-90S/80S/60S
it must first be formatted (prepared).
Formatting a floppy disk erases all information stored on the disk, and puts
it in a format that is acceptable for the device in which it will be used. If a
floppy disk is in a format that doesn’t match the format of this unit, you
won’t be able to use that floppy disk.
1. Make sure that the write protect tab of the floppy disk is in
the “Write” (permit) position.
fig.07-17
2. With the label of the floppy disk facing upward, insert it
into the disk drive until it clicks into position.
The disk drive is located to the upper right of the AT-90S/80S/60S’s
keyboard.
fig.07-17
3. Touch <Registration> on the Main screen.
The sub-window appears.
fig.03-04_55
NOTE
Formatting a disk destroys
all data previously stored
on the disk. If you’re
formatting a used floppy
disk for reuse, be sure to
check first to make sure the
disk doesn’t contain any
data you don’t want to lose.
Rear side of the disk
Write
(can write new data onto disk)
Protect
(prevents writing to disk)
Write Protect Tab
Eject buttonIndicator
Floppy Disk
Min
Max
Min
Max
Min
Max
Min
Max
Harmony Intelligence