Roland AT-300 Electronic Keyboard User Manual


 
55
Using the Registration Buttons
Using the Registration Buttons
The ATELIER allows you to store sound settings and panel settings such as 8 in
the Registration buttons. There are a total of 8 Registration buttons, and one
set of panel settings can be stored in each, allowing you to register a total of
8 different panel settings. Each set of panel settings that has been stored in a
Registration button is called a “Registration.”
This provides a convenient way to change large numbers of panel settings
during a performance, or to recall a complex panel setting.
fig.07-01
About the Registration Buttons
In addition to assigning voices and rhythms to the Registration buttons, you
can also store the following settings:
Panel button settings (for example, settings for the Level [
] and [
]
buttons and Solo [To Lower] button, etc.)
Controller settings (functions assigned to foot switches, etc.)
Other types of settings (reverb type, tempo settings, degree of initial
touch, etc.)
If you would like to know all of the settings that can be recorded to the
Registration buttons, refer to “Settings That Are Stored In the Individual
Registration Buttons” (p. 134).
The eight settings stored at the registration buttons can be saved as a “set” in
USB memory, a floppy disk, or user memory (p. 60).
In addition to the settings saved to the Registration buttons, the following data
is also saved when Registration sets are saved.
Registration Name
p. 58
Registration Shift
p. 70
Arranger Update
p. 57
Trans. Update (Transpose Update)
p. 109
Settings that have been stored
to Registration [1]–[8] buttons
are remembered even if the
power is turned off. If you wish
to restore the settings stored in
the Registration buttons to their
factory settings, use the
“Factory Reset” operation (p.
19).
6
Write
234 5 781
Manual
Recorded performance data
and rhythms from User memory
(p. 41) are not stored in
Registration sets.
When a rhythm saved in User
memory is assigned to a
Registration set, that rhythm is
copied beforehand to the User
memory.
AT-100-300_e.book 55 ページ 2008年5月7日 水曜日 午後3時33分