Filter
Top Products
66
Using the Registration Buttons
8.
Press the Value [-] and [+] buttons to select the Registration
you want to copy.
9.
Press the [Rec] button.
10.
Press the Value [-] and [+] buttons to select the copy-
destination number.
To cancel the procedure, press the [Display/Exit] button.
11.
Press the [Rec] button to copy the Registration.
If you select a number in which a Registration is already saved, a screen like
the following appears.
If you want to delete the previously saved Registration and overwrite it with
the Registration you’re newly saving, Press the [Rec] button.
If you don’t want to delete the previously saved Registration, Press the [Reset]
Button, then select a number at which no Registration has been saved, and
copy the Registration to that number.
To return to the basic screen, press the [Utility] button.
Copying Registration from User Memory to USB
Memory
You can copy Registration from user memory to USB memory.
To do so, press the [Media] button in step 7 (above) to choose “User.” In this
state, you’ll be copying Registration from user memory to USB memory.
The rest of the procedure is the same as when copying Registration from USB
memory to user memory.
NOTE
Never remove the USB memory
or turn off the power while the
registration data is being
copied from USB memory into
the ATELIER. If you do so, the
registration data will not be
loaded into the ATELIER, and
malfunctions could result. After
returning the registration stored
in the user memory to the
factory settings (p. 119), reload
the registration from USB
memory.
You can return only the user
memory to the factory settings.
Refer to “Restoring the User
Memory to the Original Factory
Settings (User Memory
Reset)”(p. 119).
AT-100-300_e.book 66 ページ ２００８年５月７日 水曜日 午後３時３３分