Filter
Top Products
19
EDIT FUNCTION
You can use the Edit function to make changes in the factory default settings and store these changes in memory. Changing
the settings on the FC-200 to match the other equipment you are using can make this MIDI foot controller even easier to
use.
How to Make Changes
The steps described below are used to make all types of changes.
1, 2
2, 6
3
4 4
1. Switch off the power.
2. While keeping down the Control pedal, switch on the power.
The display alternates between the parameter (setting item) and its value (the current contents of
the setting).
3. Use the Number pedals 1, 2, 3, and 4 to call up the parameter you wish to change and show it on
the display.
The contents of the different parameters are described in the following section, “PARAMETERS
WITH SETTINGS THAT CAN BE CHANGED” (p. 21).
Number pedal 1: The parameters cycle backward in reverse order while this pedal is kept
depressed.
Number pedal 2: Pressing this pedal changes the displayed parameter to the previous parameter.
Number pedal 3: Pressing this pedal changes the displayed parameter to the next parameter.
Number pedal 4: The parameters cycle forward in normal order while this pedal is kept
depressed.
When you stop operating the Number pedals, the display alternates between the selected
parameter and its current value.
4. Use the Bank pedals UP, DOWN or Expression pedal to change the value.
Bank pedal UP: Increases the value of the setting. For a parameter with an on/off setting, this
pedal switches the parameter on.
Bank pedal DOWN: Decreases the value of the setting. For a parameter with an on/off setting,
this pedal switches the parameter off.