Filter
Top Products
26
Setting for Latch Type Pedal Operation: On / Off
This setting determines whether the pedals work as latch type or momentary type pedals when
sending Control Change messages. A separate setting is made for each pedal.
[ ] : Latch on/off setting for Number pedal “1.”
[ ] : Latch on/off setting for Number pedal “2.”
[ ] : Latch on/off setting for Number pedal “3.”
[ ] : Latch on/off setting for Number pedal “4.”
[ ] : Latch on/off setting for Number pedal “5.”
[ ] : Latch on/off setting for Number pedal “6.”
[ ] : Latch on/off setting for Number pedal “7.”
[ ] : Latch on/off setting for Number pedal “8.”
[ ] : Latch on/off setting for Number pedal “9.”
[ ] : Latch on/off setting for Number pedal “10.”
[ ] : Latch on/off setting for Bank pedal “UP.”
[ ] : Latch on/off setting for Bank pedal “DOWN.”
[On] Latch Type:
Pressing the pedal sends an ON 127 (7Fh) message, and the pedal remains on after it is
released. Pressing the pedal again sends an OFF 0 (00h) message. The pedal indicator lights
up when on.
[Off] Momentary Type:
Pressing the pedal sends an ON 127 (7Fh) message, and releasing the pedal sends an OFF
0 (00h) message. The pedal indicator lights up when on (in other words, while the pedal is
depressed.)
Note Range Setting: C0 to C2 to C8
[ ] (Note Range)
This sets the octave for the note range of the Note messages that are sent with the pedals in the Note
mode.
The setting specifies the key number when “do” (Number pedal 1) is depressed.
* You can make a setting within the range set by the Octave Shift Upper Limit and Lower Limit
settings.
* If you need information on how to make settings for parameters, see “How to Make Changes” (p. 19).