Filter
Top Products
23
The chart below shows the programs indicated by the Bank Select and Program Change messages
shown above.
The Bank pedals and Number pedals on the FC-200 are used to send messages, and the values in
parentheses show which pedals to use to choose the corresponding program.
BANK SELECT
PROGRAM CHANGE
0
1
2
7
8
9
1 2 27 28 29 30 100 101 128
129 130 200
201 202 227 228 229 230 300
(0, 1) (0, 2) (2, 7) (2, 8) (2, 9) (2, 10) (9, 10) (10, 1) (12, 8)
102
(10, 2)
(12, 9) (12, 10) (19, 10)
(20, 1) (20, 2) (22, 7) (22, 8) (22, 9) (22, 10) (29, 10)
701 702 727 728 729 730 800
(70, 1) (70, 2) (72, 7) (72, 8) (72, 9) (72, 10) (79, 10)
801 802 827 828 829 830 900
(80, 1) (80, 2) (82, 7) (82, 8) (82, 9) (82, 10) (89, 10)
901 902 927 928 929 930 1000
(90, 1) (90, 2) (92, 7) (92, 8) (92, 9) (92, 10) (99, 10)
The program number indicated by the Bank and Number pedal values shown in parentheses is
calculated in exactly the same way as for the Program Change numbers described in “About
Program Change Numbers” (p. 11). That is, the Program number is the Bank multiplied by ten, plus
the Number (Bank x 10 + Number).
* The Bank pedals are used to select the Bank, but you can only specify a Bank whose number is
within the limit set by the Bank Limit parameter. Read the next section, “Bank Limit,” for more
details about this.
Bank Limit: 0 to 12 to 99
[ ] (Bank Limit)
In the Program Change mode, the Bank is selected with the Bank UP and DOWN pedals. This
parameter sets the upper limit for the Bank.
If the Bank DOWN pedal is depressed when the current Bank is 0, the Bank switches to the Bank
with the number set for the Bank Limit parameter. In the same way, pressing the Bank UP pedal
when the Bank is at the number set for the Bank Limit parameter, it switches to Bank 0.
As an example, let’s say that you’re sending Program Change messages to another instrument that
has 40 programs for Tones and the like. In this case, it can be handy to set Bank Limit to “3,” because
this causes only Banks 0 to 3 to be displayed.
* When the Bank Select parameter is set to “off,” Bank Limit cannot be set to a value of 13 or
higher.
* If you need information on how to make settings for parameters, see “How to Make Changes” (p. 19).