Filter
Top Products
32
Receiving Data (Bulk Load)
Making the Connections
For sending data stored on a MIDI sequencer to the FC-200, make the following connections.
MIDI INMIDI OUT
Receiving Data
1.
Make sure the MIDI channel (device ID) for the FC-200 is set to the same MIDI channel as the MIDI
sequencer where the data is stored.
* Only System Exclusive (SysEx) messages on matching MIDI channels are received.
* Refer to the MIDI sequencer’s manual for instructions on how to operate the sequencer.
2. SysEx messages can normally be received at any time while the power is switched on. The readout
on the display changes as shown below while data is being received.
* All operations and controls for the FC-200 become non-functional while SysEx messages are
being received.