Filter
Top Products
10
Getting Familiar
Tuning
1.
Press [KIT]
(*1)
, then press [CONGA], then [EDIT] and you see
<INST>. Press the [ ] cursor and you will see the instrument
name.
*1: This is only to reset this kit to the factory settings and ONLY for this basic functions explanation.
2.
Now press the [ ] once, you will see <Tuning> in the display.
Now you can use the [+]/[-] buttons or the Control knob to change the pitch.
Muffling
3.
Push the [ ] again, and you will see <Muffling> in the display.
While tapping one of the pads, use the [+]/[-] buttons or the Control knob, and you will not only hear what
is happening to the sound, but the Value meter on the right hand side of the display will indicate how much
muffling is being applied, as well as the numerical values in the display.
If you want to apply the same amount of muffling to all sounds in the kit, while holding down the [SHIFT]
button press the CONTROL knob.
The display shows <same for all>.
This function will work with all of the pad specific parameters.
Volume
4.
Press the [ ] again and you will see:
This sets the level of the sound for each pad.
Pan
5.
Press the [ ] again, and here you can adjust the position in the
stereo field of the sound for each pad.
Exiting the Edit Mode
6.
Press [EDIT], extinguishing its indicator.
HPD-10_e1.book 10 ページ ２００６年４月７日 金曜日 午後２時１４分