Filter
Top Products
23
Advanced Edit
* If you have selected a preset kit, the only functions
available here are KIT COPY and L-R EXCHANGE.
1.
To access the TOOLS, press [EDIT] and then the [ ]
until you see:
2.
Press the [ ] and you see <KIT COPY>, and the [ ]
for selecting the functions as explained below.
From the KIT COPY page press the [ ] to select the source (Src
in the display) and then press the [ ] to select the destination
(Dst in the display).
To execute, press the [ ] again, and a confirmation message
will appear in the display. Press the [4] (OK) button if OK, and
the [2] (CANCEL) button to cancel the operation.
Restoring an Individual Kit to the
Factory Settings
KIT COPY can also be used to restore the selected kit to the
original factory settings. When selecting the “source” as
mentioned above, scroll to where you see a <P: > before the kit
name.
This is a useful function for re-arranging the order of your kits.
Follow the same procedure as explained in KIT COPY.
This function completely clears all parameters assigned to all
pads.
This allows you to copy all parameters of one pad to another.
Follow the same procedure as explained in KIT COPY. In this
case you can select your source and destination pads by simply
tapping the pad or external trigger/foot switch. (MIDI Note#
will not be copied)
Here you can swap the parameters between two pads. Follow
the same procedure as explained in KIT COPY.
This function completely clears all parameters assigned to one
pad. Follow the same procedure as explained in KIT COPY.
Perfect for exchanging all pad parameters, especially if you are
Left Handed. Follow the same procedure as explained in KIT
COPY. When you select this function, the display highlights the
pads that will be exchanged. All pad parameters will be
exchanged except for the M3 pad and the S3 pad.
The undo function allows you restore the Kit to the state it was in
BEFORE you made changes to any parameter. However, if you
make changes to a kit, and then change kits, your modifications
will be permanent. If you want to UNDO any changes made,
do so before going to another kit. While holding down [SHIFT],
press the [KIT] button, and follow the commands in the display.
* When executing the UNDO function, you can preview or
compare the newly edited kit with the kit as it was before
you made changes.
When this screen appears, you can play the pads, and
you will hear the previous version.
TOOLS
KIT COPY
KIT EXCHANGE
KIT CLEAR
PAD COPY
PAD EXCHANGE
PAD CLEAR
L-R EXCHANGE
UNDO
PAD COPY/EXCHANGE
(between different kits)
You can also copy or exchange pad parameters
between two different kits. To do that, follow the same
instructions for copy or exchange, but in this case you
need to press the [SHIFT] button, and use the [+]/[-]
buttons when choosing the source or destination kit.
Upon pressing [SHIFT], you will see the KIT NAME
appear in the display, and you can listen to the sound
assigned to the pad in the destination (Dst) or source
(Src) kit.
HPD-10_e1.book 23 ページ ２００６年４月７日 金曜日 午後２時１４分