Filter
Top Products
21
Advanced Edit
1.
Select any kit.
2.
Press [EDIT], and then the [ ], until you see
<PRESSURE>.
3.
Press the [ ] once and then the [ ] again until you
see:
If this is set to OFF, raise the value.
The roll speed range is 1–30 beats per second OR
(eighth notes), (eighth-note triplets),
(sixteenth notes), (sixteenth-note triplets),
and (thirty-second notes), who’s speed will be
determined by the metronome’s current tempo setting. Set
the value as you wish.
If you want all the pads to roll, while holding down
[SHIFT], push down the Control Knob.
4.
Press any pad, or place your hand over the D Beam.
The sound will roll.
Each pad, including the D Beam can use this function.
Another way to assign the Roll function to a pad is to press
the [SHIFT] button, and tap the respective pad. Also, if you
just hold down the [SHIFT] button, the display will show
you which pads have the roll function active.
* When using the Roll function set to high speeds, and
depending on the sounds you are “rolling,” sometimes
noise may occur.
1.
Verify that the [EFFECT] button is lit.
2.
Press [EDIT], and then the [ ], until you see
<EFFECTS>.
3.
Press the [ ] and you see the EFFECT TYPE.
4.
Press the [ ] until you see the status of Pad Sw.
Each pad has its own individual EFFECT on/off switch. Set
this as you wish.
If you just hold down the [SHIFT] button, the display will
show you which pads are using EFFECTS or not.
→
If you want to assign effects to all pads, turn one pad to
the “ON” position, then while holding [SHIFT], push the
Control Knob down once. Or press [SHIFT] and tap a
selected pad.
5.
Pushing the [ ] again will take you to the various
parameters of the EFFECT selected.
You will see <D Beam> and then <Knob>. As they both
can control different parameters of the effect currently in
use, use the [+]/[-] buttons or Control Knob to see what is
possible. For an overall idea please refer to the EFFECT
chart for more details. (p. 30)
* After you have selected an effects parameter to manipulate
with the Control Knob, while you are still in the Edit mode,
you can test the function. Press the Control Knob, (the LED
will light) and then turn it while playing a pad. You will see
changes in numerical values and the bar graph in the
display. If you decide to assign a different effect parameter
to the knob, first use it to return the values to where they
were, or execute the UNDO function.
ROLL
3
3
EFFECTS
Short Cut Access to Effects Editing
While pressing the [EDIT] button, press [EFFECT]
button.
HPD-10_e1.book 21 ページ ２００６年４月７日 金曜日 午後２時１４分