Filter
Top Products
10
About Installation
When installing the S-MADI, give attention to the points described below.
The S-MADI performs forced cooling by means of a cooling fan, and is provided with an intake port and a exhaust port at the
locations shown below.
fig.intake-exhaust.eps
Never obstruct the intake port or exhaust port. Doing so may cause the temperature of the unit’s interior to rise, resulting in malfunction caused
by heat. Install the unit so that at least 2 centimeters of space are left in front of the intake and exhaust ports.
* Use a vacuum cleaner to clear away any buildup of dust or the like at the intake port or exhaust port.
You can mount the S-MADI in a 19-inch rack.
When mounting the unit in a rack, observe the following precautions.
• Install in a well-ventilated location.
• Never obstruct the intake port or exhaust port on the S-MADI.
• Use an open-type rack to ensure that hot air from the exhaust port does not remain inside the rack.
• Never mount the unit in a sealed-type rack. Heated air inside the rack cannot escape, making efficient cooling impossible. If the unit must be
mounted in a sealed rack, use a rack equipped with a ventilation fan.
• When using the unit while mounted in a portable rack, remove the front and rear rack covers before use to ensure that the intake and exhaust
ports are not obstructed.
• When mounting the unit in a rack, never attach rubber feet to the unit’s bottom panel. If they are already attached, then remove them.
• Use due caution when mounting the unit in a rack to ensure that your fingers don’t become pinched.
Important Notes When Installing
Intake Port and Exhaust Port of Cooling Fan
About Rack Mounting
Intake
Exhaust