Filter
Top Products
21
Connecting External Devices
You can add a V-Mixer to the system in “Connection Example 1” for use as a monitor console.
Connect the REAC A connector on the V-Mixer to the REAC SPLIT OUT connector on the S-MADI, and connect the REAC B
connector to the S-4000D.
* When these connections are made, you can make settings of M-48 remotely from the V-Mixer.
* Adjusting the gain on the digital snake or other settings can be accomplished using a dedicated remote controller (S-4000R) connected to the S-
MADI or using dedicated remote-control software (S-4000 RCS).
* You cannot set Digital Snake’s REAC Mode to Master when it is used in connection with S-MADI.
fig.monitor-system.eps
When making connections described here, set the modes and switches as shown below.
fig.mode-set3.eps
* Set the V-Mixer as a REAC split device by setting its REAC SETUP to [MONITOR/BROADCAST].
* Other precautions are the same as for “Connection Example 1.”
Connection Example 3 : Connecting a V-Mixer As a Monitor Console
S-4000S-3208
S-4000D
M-48
M-380
REAC Slave Device
REAC Master Device
REAC Split Device
A
B
FOH (Front of House)
STAGE
S-4000R
OUT
IN
OUT
IN
MAINSPLIT OUT
MADI MASTER
REAC IN 1-40 BNC