Filter
Top Products
16
Operating the SELECT Buttons
Press the [SELECT] buttons to change the mode of the S-MADI. The operation of the [SELECT] buttons is described below.
* We are using CLOCK SOURCE selection as an example here. The same procedures are applicable to SAMPLE RATE, REAC MAIN and REAC SPLIT
OUT selections.
When PANEL LOCK switch is set to [LOCK], the SELECT buttons cannot be operated. To enable operation, set it to [UNLOCK].
1. Check the current mode.
The indicator for the currently selected mode is lighted up. Check the CLOCK SOURCE, SAMPLE RATE, REAC MAIN, and REAC SPLIT
OUT indicators.
fig.current-mode.eps
2. Select the mode to switch to.
Press the [SELECT] button to choose the mode. Pressing the [SELECT] button starts the switching operation of S-MADI. The
indicator for the selected mode flashes during the switching operation.
* Successively pressing the [SELECT] button makes the flashing indicator change in sequence, from top down.
fig.press-select-button.eps
3. Make sure the mode has changed.
The switching operation to the selected mode is completed after about 3 seconds. The indicator that was illuminated in step 1
goes dark, and the indicator that was flashing in step 2 stops flashing and stays steadily lit.
* To prevent noise, sound is muted until the mode-change is complete.
* You can cancel the switching operation before it finishes by pressing another [SELECT] button while the indicator is flashing.
fig.mode-change.eps
You can operate the [SELECT] buttons for SAMPLE RATE and REAC MAIN only when CLOCK SOURCE is set to [REAC]. Operation is not possible
when CLOCK SOURCE is set to [MADI] or [WORD CLOCK]. These [SELECT] buttons are dark when operation is not possible.