Filter
Top Products
45
Chapter 5. Trigger Settings [TRIGGER]
Chapter 5
[TRIGGER]
When you are using pads made by other manufacturers, try
adjusting the following parameters.
The velocity monitor at the right of the screen indicates
the velocity of the last sixteen strikes, starting with the
most recent strike.
1.
Press [TRIGGER] - [F2 (BASIC)].
[TRIGGER] lights, and the “TRIGGER BASIC” screen
appears.
fig.05-TrigBasic_70
2.
Use [CURSOR (up/down)] to select the
parameter.
3.
Strike the pad you wish to set.
The setting screen for the struck pad appears.
You can also select by using [TRIG SELECT].
4.
Use [+/-] or [VALUE] to adjust the setting.
5.
When you’re finished, press [EXIT] to return to
the “DRUM KIT” screen.
You can adjust the sensitivity of the pads to accommodate
your personal playing style.
This allows you to have more dynamic control over the sound
volume, based on how hard you play.
Sensitivity:
1–32
Higher sensitivity allows the pad to produce a loud volume
even when played softly.
Lower sensitivity will keep the pad producing a low volume
even when played forcefully.
This setting allows a trigger signal to be received only when
the pad is above a determined force level (velocity). This can
be used to prevent a pad from sounding because of vibrations
from other pads.
In the following example, B will sound but A and C will not
sound.
fig.Threshold.e
Threshold:
0–31
When set to a higher value, no sound is produced when the
pad is struck lightly.
Gradually raise the “Threshold” value while striking the pad.
Check this and adjust accordingly. Repeat this process until
you get the perfect setting for your playing style.
This setting allows you to control the relation between playing
velocity (striking force) and changes in volume. Adjust this
curve until the response feels as natural as possible.
Curve:
LINEAR
The standard setting. This produces the most natural
correspondence between playing dynamics and volume
change.
fig.VeloC-LINEAR.e
Curve:
EXP1, EXP2
Compared to LINEAR, strong dynamics produce a greater
change.
fig.VeloC-EXP.e
Setting the Pad Sensitivity
[F2 (BASIC)]
Parameter
Value Description
Trig Type
refer to p. 44
Sensitivity 1–32 Pad sensitivity
Threshold 0–31 Minimum level
for the pad
Curve LINEAR, EXP1,
EXP2, LOG1,
LOG2, SPLINE,
LOUD1, LOUD2
How playing dy-
namics changes
the volume
Pad Sensitivity
Minimum level for the pad
(Threshold)
How Playing Dynamics Changes the
Volume (Velocity Curve)
Threshold
CBA
Volume
Striking Force
LINEAR
Volume Volume
Striking Force
EXPONENTIAL 2EXPONENTIAL 1
TD-12_e.book 45 ページ ２００５年５月３１日 火曜日 午後１時３２分