Filter
Top Products
59
Chapter 6. Sequencer (Playback)
Chapter 6
[PLAY]
* Drum part cannot be set here. Set in the MIXER settings (p.
39).
* To adjust volume/pan settings for each instrument of the
percussion part, refer to p. 57.
1.
Press [PATTERN] - [F2 (PART)].
The “PATTERN PART” screen appears.
2.
Press [F3 (MIXER)].
The “PART VOLUME”, “PART PAN”, or “PART
REVERB SEND LEVEL” screen appears.
fig.06-Mixer_70
3.
Press [F1]–[F3] to select the parameter.
4.
Press [CURSOR (left/right)] to select the part
you wish to set.
5.
Use [+/-], [VALUE], or [CURSOR (up/down)] to
make settings.
Set the amount of reverb and chorus for each backing part.
1.
Press [PATTERN] - [F2 (PART)].
The “PATTERN PART” screen appears.
2.
Press [F3 (MIXER)] - [F4 (REVERB)].
The “REVERB” screen appears.
fig.06-Rev_70
3.
Press [CURSOR] to select the parameter.
4.
Use [+/-] or [VALUE] to make settings.
5.
Press [F5 (REV SW)] to turn the reverb ON or
OFF.
Volume/Pan Settings for Each Part
[F3 (MIXER)]
Parameter Value
[F1 (VOLUME)]
PART VOLUME 0–127
[F2 (PAN)]
PART PAN L15–CTR–R15
[F3 (REV SND)]
PART REVERB SEND LEVEL 0–127
Reverb Settings for Backing Parts
[F3 (MIXER)] - [F4 (REVERB)]
Parameter Value Description
REVERB
Type ROOM1, ROOM2,
STAGE1, STAGE2,
HALL1, HALL2,
DELAY, PAN-DELAY
Type of reverb
Time 0–127 Reverb Length/
Delay Time
TD-12_e.book 59 ページ ２００５年５月３１日 火曜日 午後１時３２分