Filter
Top Products
56
Chapter 6. Sequencer (Playback)
PATTERN PART screen
fig.06-Part_70
Here you can select the instrument used for the backing parts
(other parts than drum kit part and percussion part), etc.
1.
Press [PATTERN] - [F2 (PART)].
The “PATTERN PART” screen appears.
2.
Press [F1 (BACKING)].
The “MELODY (BASS, BACKING1, BACKING2) PART”
screen appears.
fig.06-Backing_70
3.
Press [F1]–[F4] to select the part you wish to
set.
[F1]: Melody Part
[F2]: Bass Part
[F3]: Backing 1 Part
[F4]: Backing 2 Part
4.
Press [CURSOR (up/down)] to select the
parameter.
5.
Use [+/-] or [VALUE] to make settings.
Here you can adjust the overall tuning for the Melody, Bass,
Backing 1, and Backing 2 part.
1.
Press [PATTERN] - [F2 (PART)] - [F2
(BACKING)] - [F5 (M TUNE)].
The “MASTER TUNE” screen appears.
fig.06-Tune_70
2.
Use [+/-] or [VALUE] to make setting.
Master Tune:
415.3–466.2Hz
* You can set this to 440.0 Hz by pressing [F5 (440 Hz)].
Part Settings [F2 (PART)]
Make Settings for the Backing Part
[F1 (BACKING)]
Parameter Value Description
Inst Refer to
Backing
Instrument List
(p. 94)
Part Instrument
Key Shift -24–0– +24 Shifts the overall
pitch (in semi-
tone steps).
Bend Range 0– +24 Amount of
change in pitch
with pitch bend
at the maximum
level (in semitone
steps).
Master Tuning
Instrument Numbers/Instrument
Names
You can change the tone by changing the instrument
number. Selecting different variations within each
instrument number changes the instrument name, with a
different tone being selected.
Instrument numbers correspond to the program numbers
(1-128).
Variation Tones
These are slightly varied tone types found in an
instrument number. The number of variation tones varies
with the instrument number.
fig.06-Variation_70
Number of
Variation Tones
Instrument Name
TD-12_e.book 56 ページ ２００５年５月３１日 火曜日 午後１時３２分