Filter
Top Products
18
Preparations
fig.battery3_69
7. Reinstall the effect expansion board (VS8F-2) if removed in Step 5. Insert
the plastic pin in the VS8F-2’s hole, making sure the board is securely
fastened in place.
8. Use the screws that you removed in step 2 to fasten the cover back in place.
This completes the process of exchanging the lithium battery.
9. Connect the cables that you disconnected earlier.
10. Turn on the power, as described in “Turning On the Power (p. 19).”
11. Confirm that the message warning that the lithium battery is depleted does
not appear in the display.
12. Set the current time (p. 22).
Basic Connections (Power Supply, Audio
Devices and Headphones)
fig.01-11j_60
If you are using headphones, connect them to the rear panel PHONES 1 or PHONES
2 jack. The PHONES jack will output the same signal as the MONITOR jacks.
When you purchase the VS-2480/2480CD, it will be set so that all analog audio
signals are output from the MASTER jacks. The MONITOR jacks will output the
same sound as the MASTER jacks.
fig.01-12
A CR2032 lithium battery is
used for the
VS-2480/2480CD. This type
of battery is available at an
electric appliance, or
similar store.
The internal clock is
powered by the lithium
b
attery. Changing the
lithium battery may cause
this clock to stop, or may
result in the current time
b
eing altered. Always
make sure to newly set the
correct time after the
lithium battery has been
replaced.
For details refer to Owner’s
Manual “Working with the
VS-2480 Output. (p. 287)”
Stereo Set, etc.
Stereo Headphones
(RH-25, RH-50, etc.)
WORD CLOCK IN
VGA OUT
SCSI
POWER
ON
AC IN
RLRLRL
FOOT
SWITCH
MONITOR AUX AAUX B
34
RL
MASTER
125678PHONES 1PHONES 2
ANALOG MULTI OUTPUT
KEYBOARD
SMPTE
IN
MOUSE
MIDI
INOUT /THRU
PS/2
OUT IN
OUT IN
DIGITAL
OPTICAL
2
COAXIAL
THIS DEVICE COMPLIES WITH PART 15 OF
TO THE FOLLOWING TWO CONDITIONS:
THE FCC RULES. OPERATION IS SUBJECT
(
1
)
THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND
(
2
)
THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY
CAUSE UNDESIRED OPERATION.
DIGITAL 8ch I/ ODIGITAL 8ch I/ O
1
+
4dBu BALANCED / -2dBu UNBALANCED
(
TIP
)
(
RING
)
(
SLEEVE
)
HOT
COLDGND
To Power Outlet Ground (Earth)