Filter
Top Products
39
Using the components
Muting the devices
Muting the bodypack transmitter
̈ Slide the MUTE switch · to the left, to “MUTE“.
̈ The red LED LOW BATT/MUTE ¶ lights up perma-
nently. The MIC level display ብ no longer shows
any deflection. The bodypack transmitter’s micro-
phone input is muted.
Note:
The muting function (MUTE) mutes the microphone
input » but not the line input ¿. This function
enables a pre-recorded track to be played through
the line input without being disturbed by the tour
guide’s microphone. When the track has finished,
the guide can un-mute the microphone and con-
tinue talking.
To deactivate the muting function:
̈ Slide the MUTE switch · back to the right.
The red LED LOW BATT/MUTE ¶ goes off. The MIC
level display ብ and the LINE level display ቦ indi-
cate the current levels.
Muting the radio microphone
̈ Turn the protective cap ² so that the MUTE
switch ¹ becomes accessible.
̈ Slide the MUTE switch ¹ in the direction of the
arrow.
“MUTE” appears on the display of the radio micro-
phone. After 5 minutes, “CH OFF” appears on the
display (see “Display of the energy saving mode”
on page 16).
To deactivate the muting function:
̈ Slide the MUTE switch ¹ back in order to transmit
the audio signal again.
LINE
CH 03
MIC
ብቦ
»
¿
²
¹