Filter
Top Products
9
How to Control the Display from the SRP-X700P
PROJECTOR CONTROL RS-232C Terminal
To connect the RS-232C terminal of applicable projectors and that of plasma display to this terminal;
This model can switch the input signals and power ON/STANDBY of the projector and plasma display in interlocked condition.
<SRP-X700P side>
(D-sub 9-pin, male)
<Sony projector/
plasma display side>
(D-sub 9-pin, female)
PROJECTOR CONTROL CONTROL S IN/OUT Terminal
PROJECTOR
IN
OUT
<SRP-X700P>
CONTROL S
Remote
commander
Projector
The SRP-X700P can switch the input signals and power ON/STANDBY of
the projector automatically when CONTROL S cable is connected to Sony’s
projector as interlocked operation. The RGB signal and the component
signal cannot be connected at the same time for the interlocked operation.
Connect the wired remote commander supplied with a projector to the
CONTROL S IN terminal. Then you can establish various setups of a
projector from the SRP-X700P. If you want to use the wired remote
commander on battery, locally fabricate a connecting cord with STEREO
mini plug connected at one end, for supplying the power.
Pin No. Signal Function
1 FG Frame ground
2 RD Receive data
3 TD Send data
4 ER Not connected
5 SG Signal line ground
6 DR Not connected
7 RS Not connected
8 CS Not connected
9 N. C Not connected
Pin No. Signal Function
1 FG Frame ground
2 RX DA Receive data
3 TX DA Send data
4 DTR Data terminal ready
5 GND Ground
6 DSR Data set ready
7 RTS Request to send
8 CTS Clear to send
9 RI Called display
How to Control the SRP-X700P from External Equipment
REMOTE RS-232C Terminal
Use of this terminal enables you to control the SRP-X700P from an external
controller.
Terminal shape : D-sub 9-pin, male (with inch-type screws)
Electrical specifications : Conforms to RS-232C standard
Recommended cable : Multi-core shielded cable for data communication
Cable length : 15 m or less
Communication format
Baud rate : 9600 bps
Bit length : 8 bits
Stop bit : 1 bit
Parity : ODD (odd number)
Note
Use the null modem cable when connecting the SRP-X700P with computer.
Pin No. Signal Function
1 FG Frame ground
2 RD Receive data
3 TD Send data
4 ER Not connected
5 SG Signal line ground
6 DR Not connected
7 RS Not connected
8 CS Not connected
9 N. C Not connected
Note
The USB terminal and the REMOTE USB terminal are the dedicated terminal to control this unit from the SRP-X700P Manager and User
Control Panel.
For the projectors that the SRP-X700P supports by default, refer to the “List of supported projectors” on a separate document.