Filter
Top Products
7. GROUP OUTPUT
The Group outputs are driven by ground compensated
amplifiers to a standard
1
⁄
4
" 3 pole ‘A’ gauge jack socket.
M A STER SEC TI O N
8. D.C. POWER SOCKET
The cable from the power supply connects to the console via
this 5-pin socket.
Ensure that you always use the correct power supply for your
console. The 12, 16 and 24 channel frame sizes require the
DCP100 power supply and the 32 channel frame uses the
CPS150 power supply.
9. MONO OUTPUT
The ground compensated MONO output is a sum of the
postfade Mix Left and Right outputs, providing a separately
controlled feed which may for instance be used to drive a
centre loudspeaker cluster via a suitable power amplifier.
10. MIX L & R OUTPUTS
The MIX L & R outputs are standard male XLR-3 connectors,
driven by ground compensated amplifiers.
11. INSERTS
These are similar to the Input Channel Inserts and allow
external processing equipment to be ‘inserted’ into the output
signal path. The
1
⁄
4
" 3 pole ‘A’ gauge jack sockets are
by-passed except when a plug is inserted.
1 2 . BA RG RA PH M ETERS
Six 12-segment, three colour bargraph meters provide visual
monitoring of the levels of the Mix Left and Right, and Group
outputs. All the meters are peak reading.
Normally the Left and Right meters show the level of the Mix
Left and Right outputs. If any PFL or AFL switch is activated
the left meter is turned off and the right meter displays the
level of the selected PFL or AFL signal.
The bargraphs may be calibrated by trimmers accessed via
holes in the panel below each meter. Adjustments may be
made using a small screwdriver, taking care not to damage
the trimmers.
M A STER
Pa g e 18