Filter
Top Products
Re configuring Aux 2 a s a Post Fa de Send
Aux 2 is configured as a PRE FADE send at the factory, but
may be altered to be POST FADE if required by repositioning
a link on the Input PCB SC3209 as shown below.
R52
R56
R54
J1
J1
PRE
PRE
J2
J2
POST
POST
INPUT BOARD SC3209
R48
C28
C27
R51
R50
L10
To change AUX 2 to POST FADE, remove the PCB from the
console and carefully unsolder link J1 using the minimum of
heat to avoid the possibility of tracks lifting on the PCB.
Replace the link in position J2.
This operation should only be carried out by competent
technicians who possess the necessary soldering skills.
Pa g e 28