Filter
Top Products
3 – Automation overview : AUTO CONFIG
14 TASCAM DM-3200 Automation Guide
AUTO CONFIG
The grid represented in the AUTO CONFIG display is
used for manual override of the automation’s mode
switching. The selected channel is displayed in the
upper left of the display. If the displayed channel is
part of a group, this is indicated in the upper right of
the grid.
The changes made in this grid are applied to channel
and controls selected by the
APPLY TO buttons at the
right of the display. Use the rightmost POD encoder
to make this selection. Note that it is not necessary to
press
ENTER to confirm this setting.
When a module or control is set to any mode except
Auto using this display, that module or control
remains in that mode until it is reset back to
Auto.
The settings made in this display are saved as part of
the mix data.
MODULE When selected, the changes in this dis-
play will only be applied to the specified control on
the selected channel.
ALL MODULE When selected, the changes in this
display are applied to a single control across all chan-
nels. For example, with
ALL MODULE selected,
enabling
SAFE in the FADER row places all mixer faders
into Safe mode.
ALL CNTRLS When selected, the changes in this
display are applied to all controls on the selected
channel. This applies the changes to the libraries.
ALL When selected, the changes in this display are
applied to all controls on all channels.
COPY This soft key copies the configuration of the
currently-selected channel into a special clipboard
where it can then be pasted to another channel. A
popup message appears when this operation is car-
ried out.
PASTE This soft key (only visible when a configura-
tion has been copied) pastes the configuration copied
using the
COPY soft key to the currently-selected
channel. Note that there is no Undo for this opera-
tion.
Undo/Redo
The UNDO/REDO key provides one level of undo (or
if an action has been undone, one level of redo) for
dynamic and static controls.
It is a global undo/redo, undoing or redoing all mix
moves in a pass.
Undo and redo is not possible if timecode has been
stopped and no events have been modified.
Figure 3.4: AUTO CONFIG display