Filter
Top Products
4 – Operation : Writing Mix Moves
TASCAM DM-3200 Automation Guide 21
Write To End:
When the Write Revert Time is set to ∞s, you are
essentially telling the automation system to maintain
a control’s last setting from the point where the auto-
mation recording ends, all the way to the end of the
program. This is called Write To End. In this case,
any mix moves existing in the time between the end
of automation recording and the end of the program
will be erased.
NOTE
A Write/Trim to End operation must be completed by
stopping the timecode. Manually disabling Write or
Trim mode while timecode is running will not perform a
Write To End operation.
AUTO REVERT must be enabled to use Write To End.
See the diagrams below to understand how this
works:
Figure 4.9: Write to End over previous Static fader position
8 sec
8 sec
+12
+6
+3
0
-3
-6
-12
+12
+6
+3
0
-3
-6
-12
1 sec
2 sec 3 sec
4 sec
5 sec
6 sec
7 sec
1 sec
2 sec 3 sec
4 sec
5 sec
6 sec
7 sec
-9
Existing Static Fader Position
Mix Move
Touch Fader Release Fader Stop Time Code
Fader
Movement
Figure 4.10: Write to End over previous Dynamic fader moves
8 sec
8 sec
+12
+6
+3
0
-3
-6
-12
+12
+6
+3
0
-3
-6
-12
1 sec
2 sec 3 sec
4 sec
5 sec
6 sec
7 sec
1 sec
2 sec 3 sec
4 sec
5 sec
6 sec
7 sec
-9
Existing Fader Move
Mix Move
Touch Fader Release Fader Stop Time Code
Fader
Movement