Filter
Top Products
4 – Operation : Writing Switch Events
26 TASCAM DM-3200 Automation Guide
Write To End:
When the Write Revert Time is set to ∞s, you are
essentially telling the automation system to maintain
that control’s last setting from the point when auto-
mation recording ends, all the way to the end of the
program.
NOTE
A Write/Trim To End operation must be completed by
stopping the timecode. Manually disabling Write or
Trim mode while timecode is running will not perform a
Write To End operation.
AUTO REVERT must be enabled to use Write To End.
This is called Write To End. In this case, any switch
events existing in the time between the end of auto-
mation recording and the end of the program will be
erased.
See the diagram below to understand this Write to
End behavior:
Figure 4.15: Writing a new switch event with Write to End enabled
8 sec
8 sec
8 sec
1 sec
2 sec 3 sec
4 sec
5 sec
6 sec
7 sec
1 sec
2 sec 3 sec
4 sec
5 sec
6 sec
7 sec
1 sec
2 sec 3 sec
4 sec
5 sec
6 sec
7 sec
Existing Switch Events
New Switch Events
Resulting Switch Events
Switch ON
Switch ON
Switch ON Switch ON
Switch OFF
Stop Time Code
Switch OFF
Switch OFF
Switch OFF