Filter
Top Products
4 – Operation : Trimming Mix Moves
30 TASCAM DM-3200 Automation Guide
Trim To End
When the Trim Revert Time is set to ∞s, you are
essentially telling the automation system to maintain
the offset created by the trim operation from the point
where trimming ends, all the way to the end of the
program.
NOTE
A Write/Trim To End operation must be completed by
stopping the timecode. Manually disabling Write or
Trim mode while timecode is running will not perform a
Write To End operation.
See the diagrams below to understand how this
works:
Figure 4.20: Trimming fader moves with Trim to End enabled
8 sec
8 sec
+12
+6
+3
0
-3
-6
-12
+12
+6
+3
0
-3
-6
-12
1 sec
2 sec 3 sec
4 sec
5 sec
6 sec
7 sec
1 sec
2 sec 3 sec
4 sec
5 sec
6 sec
7 sec
-9
Existing Fader Move
Mix Move
Raise Fader & Release Stop Time Code
Figure 4.21: Trimming POD and encoder moves with Trim to End enabled
8 sec
8 sec
+12
+6
+3
0
-3
-6
-12
+12
+6
+3
0
-3
-6
-12
1 sec
2 sec 3 sec
4 sec
5 sec
6 sec
7 sec
1 sec
2 sec 3 sec
4 sec
5 sec
6 sec
7 sec
-9
Existing POD Move
Mix Move
Move POD & Release Stop Time Code