Filter
Top Products
4 – Operation : Trimming Mix Moves
28 TASCAM DM-3200 Automation Guide
Auto Revert Choices:
With AUTO REVERT — TRIM enabled, the automation
system stops trimming mix moves automatically per
control without the need to stop trimming manually.
In this case, controls stop trimming mix moves at dif-
ferent times, depending on when they were released
(faders) or when movement ended (POD controls), or
when the timecode was stopped.
In the case of the touch-sensitive faders, the revert
starts when the fader is released. In the case of POD
controls and encoders, revert starts when the
CONTROL
SENSE TIME OUT
has expired without movement of the
control.
CONTROL SENSE TIME OUT allows the POD con-
trols to respond as if they are touch-sensitive even
though they are not.
When a Revert occurs, the control smoothly matches
back to its previous data based on the amount of
Revert Time set. That previous data could be a con-
trol’s Static position or a control’s Dynamic mix
moves. See the diagrams below to understand how
this works:
Figure 4.16: Trimming fader moves with Auto Revert enabled
8 sec
8 sec
+12
+6
+3
0
-3
-6
-12
+12
+6
+3
0
-3
-6
-12
1 sec
2 sec 3 sec
4 sec
5 sec
6 sec
7 sec
1 sec
2 sec 3 sec
4 sec
5 sec
6 sec
7 sec
-9
Existing Fader Move
Mix Move
Raise Fader Release Fader or Stop Timecode
Revert
Time
Hold Fader
Figure 4.17: Trimming POD and encoder moves with Auto Revert enabled
8 sec
8 sec
Control
Sense
Timeout
+12
+6
+3
0
-3
-6
-12
+12
+6
+3
0
-3
-6
-12
1 sec
2 sec 3 sec
4 sec
5 sec
6 sec
7 sec
1 sec
2 sec 3 sec
4 sec
5 sec
6 sec
7 sec
-9
Existing POD Move
Mix Move
Move POD Release POD Time out or Stop Timecode
Revert
Time
POD Movement