Filter
Top Products
21
For proper tandem connections, select the TANDEM setting to ‘ON’ in the TO SLOT screen of the
D-I/O Input Setup Section.
To operate MMC, set the MMC PORT to ‘MIDI’ in the MIDI SETUP screen of the TANDEM MASTER
unit. In this case, the MIDI channel of MMC should be set at the same MIDI channel of MMC to be
received on the BRC.
To send/receive the MIDI messages, set the PORT of Gen.Rx and Gen.Tx to ‘MIDI’ in the MIDI
SETUP screen. For the TANDEM SLAVE unit, set the SEND/RECEIVE of the various MIDI messages
to ‘THRU.’
For MTC reception on the WR-DA7, set MTC PORT to ‘MIDI’ in the MIDI SETUP screen of the
TANDEM Master unit.
To obtain the MTC timecode display on the LCD screen set the TIME BASE to ‘MTC’ in the
AUTOMATION EXECUTE screen of the Automation SETUP SECTION.
(To use SMPTE timecode connect the WR-SMPTE card, and set the TIME BASE to ‘SMPTE.’)
ADAT setting
For ADAT wordclock setting, connect a Sync cable from the BRC and turn on the power supply.
The setting is automatically set to ‘EXT’ and the ADAT functions as a SLAVE to the BRC.
The ADAT ID numbers are automatically set in the order of the SYNC cable connections from
SYNC OUT to SYNC IN.
The power supply of each ADAT should be turned on first, then turn ON the power supply of the
BRC.
To use the digital input of the ADAT, the DIGITAL IN button should be selected S on the ADAT’s
front panel.
During ADAT playback if ALL INPUT is ON there will be no playback. ALL INPUT must be turned
OFF.
BRC setting(BRC as the wordclock master)
Select the Fixed Mode when the BRC is used as the wordclock master and set the sampling rate to
48kHz. When the sampling rate is set to 44.1kHz select the Variable Mode and press the PITCH
DOWN switch to a setting of-147cent ( ‘44.1’ display).
To obtain a through output of the MIDI message received on the BRC, press the BRC’s MIDI/UTIL
button repeatedly to display the MIDI ECHO screen and select the ON setting.
For setting MTC, display the MIDI screen by pressing the GEN SYNC button to select a setting of
‘MTC.’ Press the EDIT button to exit the edit mode then, press the GEN SYNC button to enable
sync generation.
For setting SMPTE, press the GEN SYNC button to display SMPTE: and use the UP/DOWN to select
‘-10dB’ then, press the EDIT button to exit the edit mode press the GEN SYNC switch to enable
SMPTE sync the LED will light.
To obtain a timecode output from the BRC even during FF/REW operations of the ADAT, obtain a
display of 8: Output Rew/FF SMPTE & MTC: for ‘ON’ in MIDI/UTIL setting of the BRC.